Autostart CT-5000 User Manual
Ct-5000, Installation guide
Notice
The manufacturer will accept no responsibility for any electrical damage resulting from
improper installation of the product, be that either damage to the vehicle itself or to the
Unit. This Unit must be installed by a certified technician using all safety devices
supplied. Please note that this guide has been written for properly trained Autostart
technicians, a certain level of skill and knowledge is therefore assumed. Please review
the Installation Guide carefully before beginning any work.
Warning
This unit is designed for vehicles with an
automatic
Transmission only.
Before installing the Unit, test that the vehicle will not start if the gear select lever is in the
“Drive” position. If the vehicle starts in gear, install a manual-transmission Car Starter
instead.
DOC: 3.55
CA
–
September 9, 2004
Manufactured in Canada by Autostart
A U T O M A T I C T R A N S M I S S I O N R E M O T E S T A R T E R
S Y S T E M
CT-5000
Installation Guide
Document Outline
- Introduction
- Included in the Package
- Installation Tools:
- Before You Get Started…
- Harness Description
- Flashing the Hood Pin
- The Programming Assistance Button (A.k.a. PAB.)
- How to Program the Transmitter.
- How to Enter Options Programming Mode
- Options Programming
- Multi-Speed Tach Programming
- Testing
- Closing Up
- Supplementary Information
- Resetting The Module
- Events Logging
- Intrusion Codes via LED light
- Installation Order
- A basic introduction to the Relay:
- Troubleshooting Poor Transmitting Range
- Trouble shooting Q & A
- Chirps
- Diagnostics - Parking Lights Flash Rate