Rhino Shelter ROUND-30W X 40L X 15H - Manual (Page 17)

Assembly Instructions Round Style 30x40x15
Industrial Round Style Building
17
Version 2.0
Please DO NOT return unit to store or dealer. For all questions or shortages please contact
Customer Service at: 800-447-7079 or 203-877-7070
Maintenance and Care
Annually or more often, the unit should be completely
inspected internally and externally to make certain the
unit remains properly installed and secured. Particular
attention should be paid to:
Hardware – check all carriage bolts and hardware
connectors to be certain they are in place and tightened.
Base Plate Anchors – during normal weather trends, the
unit will strain against the base plate anchors under
windy conditions. Anchor hardware connection to frame
members should be maintained tight and depth of
anchors should be checked to be certain they remain
deeply and firmly set.
Snow Accumulation – All snow accumulation on the
main cover should be removed as soon as possible. Tap
the main cover from the inside with a broom or soft
brush to clear cover.
Main Cover Lacing – the poly rope that secures the main
cover to the bottom rail of the frame assembly should be
checked, and adjusted as needed. The tension on the
main cover should be uniform from end to end and side
to side. Rope ends must be tied off onto the frame
members at the ends on each side.
Cleaning – cover and doors can be cleaned with a
mixture of light detergent and water. A soft bristle brush
with the mixture can be used to loosen any hard dirt,
mold, or buildup on the cover. After cleansing, the cover
should be rinsed thoroughly to avoid any chemical
reaction from residual detergent. Allowing dirt and
debris to sit on cover over an extended time will damage
cover irreparably.
Severe Weather – in preparation for inclement weather,
completely secure the door of your MDM Products
portable building. Allowing wind to enter end lifts the
building and puts undue stress on the anchoring system.
This also shortens the life of the doors and main cover.
Customer Service or Installation Assistance
Please call MDM Products at 800-447-7079 or 203-877-
7070 for questions about the proper installation of the
unit in any way. Care and attention to a proper
installation will add many years of life and function to
your MDM Products unit.
Please retain purchase documentation for your MDM
Products unit. All warranty claims must include purchase
documentation for verification. All parts on your MDM
Products unit are available for replacement as needed.
Protect your purchase by completing warranty
registration card and mail/fax as soon as practical after
installing your unit.
Thanks again for choosing this quality product. With
proper operation and care we are confident it will meet
your expectations in functionality, appearance and
longevity.