LumaSense Technologies M335 - Manual (Page 11)

M335 Manual Operation 11
3 Operation
3.1 Starting Up
1. Allow the M335 to warm-up to room temperature for at least two hours after
unpacking and prior to applying power.
Note: The first time the M335 is used, or when left idle for a long period of time, the
temperature setting of the controller should be raised gradually until all trapped water
vapor has dissipated.
2. Connect the power cable. Make sure to note the power requirement specification on the
Specification Label located on the rear of the M335.
3. Turn on the power switch/breaker and allow 20 seconds for the system to self test.
Warning: Do not connect or disconnect while power is on. Do not attempt to operate
without cables connected.
3.1.1 Front Panel Push Buttons
PAGE Engages access to controller parameters. Do not alter any
configurations.
SCROLL Engages access to menu items underneath the Page menu.
Allows viewing of output power, working setpoint, and
target setpoint.
UP/DWN Used to raise and lower the temperature setpoint.
3.2 Changing the Setpoint
Press either the UP/DWN buttons on the controller. Each press will advance the setpoint 1
degree. To advance faster, press and hold for 5 seconds until it advances a few degrees/second.
Let go when it is near the desired setpoint. Press again to bring it to the exact value desired.
Note that this setpoint will be retained when power is turned off.
Warning: DO NOT EXCEED THE MAXIMUM TEMPERATURE OF 1500 °C.