LumaSense Technologies MIKRON M7815 - Manual (Page 2)

Button Control Functions
No. Description Function
1 Power Button Used to turn the power on and
off.
2 Menu Button Used to access the menu system
and to cancel out of certain menu
functions.
3 Focus Buttons Used to focus in and focus out.
4 Joystick
Button Used to navigate through the
main menu functions and to gain
access to the quick menu func-
tions.
5 Save Button Saves the current image data
in either the “run” or “freeze”
modes.
6 Trigger
Button Used to activate the target laser.
Also used to freeze an image and
return to the run mode. It can
also be configured to serve as an
alternate save button. As such, it
would automatically freeze the
image, save the image and then
return to the run mode.
Unpacking and Inspection
The M7815 thermal imaging camera is shipped in a
rugged and padded carrying case along with two battery
packs, a battery charger, AC Adapter and AC power cable,
USB cable, lens cap, software and operating manual.
When unpacking and inspecting the camera, you
need to do the following:
1) Check container contents against the shipping list.
2) Carefully unpack and inspect all components for vis-
ible damage.
3) Save all packing materials, including the carrier’s
identification codes, until all components are
inspected and no obvious or hidden damages were
found.
Before shipment, the camera was assembled, cali-
brated, and tested at the LumaSense Factory. If any
damage or suspect damage is noted, immediately
contact the carrier and LumaSense.
Charging the Batteries
Step 1 Step 2
Step 3 Step 4
1) Plug the battery charger power cord into a standard
wall outlet.
2) Position one battery pack on the battery charger by
aligning the brackets and terminal ports on the bat-
tery pack to those on the charger.
3) Press down on the battery pack while sliding it for-
ward into position.
4) Repeat steps 2 and 3 for the second battery pack.
[1] Power Button
[3] Focus
Buttons [4] Joystick
Button
[2] Menu
Button
[5] Save Button
[6] Trigger Button