LT Security LTD831J5 - Manual (Page 41)

41
4/8/16CH Triplex DVR
Digital Video Recorder
5.4.1.
sor mode as “Not Installed”, “Normal-Open” or “Normal-Close”.
To set the sensor’s record time as 5sec, 10sec, 15sec, 20sec, 25sec,
sec, 90sec, 120sec, 150sec or 180sec.
de
Sensor Mode
Set the sen
5.4.2. Record Time
30sec, 45sec, 60
5.4.3. Alarm Mo
To set the motion detector alarm mode.
“Mute”: No beep whatever detecting.
“ Buzzer-Short”: Beep shortly by buzzer on main board when
detection is active
“ Buzzer-Long”: Beep long by buzzer on main board when detection
is active
“ Alarm-Short”: Beep shortly by speaker of system when detection is
active
Alarm-Long”: Be “ ep long by speaker of system when detection is
To Setup the time period of beep by “Nonstop”(no stop), 5sec, 10sec,
15sec, 20sec, 25sec, 30sec, 35sec, 40sec, 45sec, 50sec, 55sec or 60sec
5.4.5. Trigger Full Screen
Display the trigger channel on full screen when it act as 1, 2sec … 30sec.
active
5.4.4. Alarm Time
“ OFF”: It will not display on full screen when the channel has been
triggered.
ype
There are two trigger types: “Initial Trigger” and “Continuous Trigger” for
selection.
Initial Trigger: When channel has been triggered, it will display on full
screen as the setting time period. In that time period, this channel will
ignore any other trigger.
Continuous Trigger: When channel has been triggered, it will display on
full screen as the setting time period. In that time period, this channel is
still watching out. If anot r r ger act, the channel will display on full
all over again by the setting time period.
5.4.6. Trigger T
he t ig
screen and count