Lincoln Electric IM660 RANGER 200 - Manual (Page 11)

A-3 INSTALLATION
RANGER 200
A-3
HIGH ALTITUDE OPERATION
It may be necessary to de-rate the welder output at
higher altitudes. De-rate the welder output 3.5% for
every 1000 ft. (305m) above 5000 ft. (150 m). Some
engine adjustment may be required above 5,000 ft.
(1,525 m).
HIGH TEMPERATURE OPERATION
At temperatures above 30°C, output de-rating is nec-
essary. For maximum output current ratings, de-rate
the welder output 5% for every 10°C above 30°C.
LIFTING
The RANGER 200 weighs approximately 490lbs / 222
kg. A lift bail is mounted to the machine frame and
should always be used when lifting the machine.
ADDITIONAL SAFETY
PRECAUTIONS
FALLING EQUIPMENT can cause
injury.
● Do not lift this machine using lift bale if it is
equipped with a heavy accessory such as trailer
or gas cylinder.
● Lift only with equipment of adequate lifting
capacity.
● Be sure machine is stable when lifting.
The recommended trailer for use with this equipment
for in-plant and yard towing by a vehicle
(1) is Lincoln’s
K957-1. If the user adapts a non-Lincoln undercarriage,
he must assume responsibility that the method of
attachment and usage does not result in a safety haz-
ard nor damage the welding equipment. Some of the
factors to be considered are as follows:
1. Design capacity of trailer vs. weight of Lincoln equip-
ment and likely additional attachments.
2. Proper support of, and attachment to, the base of
the welding equipment so there will be no undue
stress to the framework.
3. Proper placement of the equipment on the trailer to
insure stability side to side and front to back when
being moved and when standing by itself while
being operated or serviced.
WARNING
4. Typical conditions of use, i.e., travel speed; rough-
ness of surface on which the trailer will be operat-
ed; environmental conditions; likely maintenance.
5. Conformance with federal, state and local laws.(1)
(1) Consult applicable federal, state and local laws regarding
specific requirements for use on public highways.
PRE-OPERATION ENGINE SERVICE
READ and UNDERSTAND the engine operating and
maintenance instructions supplied with this machine.
------------------------------------------------------------------------
• Keep hands way from the engine muffler or HOT
engine parts.
• Stop the engine when fueling.
• Do not smoke when fueling.
• Do not overfill the fuel tank.
• Wipe up spilled fuel and allow the fumes to clear
before starting the engine.
• Keep sparks and flame away from the fuel tank.
------------------------------------------------------------------------
OIL
The RANGER 200 is shipped with the engine filled
with SAE 10W-30 oil. CHECK THE OIL LEVEL
BEFORE YOU START THE ENGINE. Check the oil
level every four hours of running time during the first
25 running hours. Refer to the engine Operator’s
Manual for specific oil recommendations and break-in
information. The oil change interval is dependent on
the quality of the oil and the operating environment.
For more information on oil viscosity and service con-
ditions, see the MAINTENANCE section of this manu-
al and the engine Operator’s Manual.
WARNING
CAUTION