Hired-Hand PowerTrak: Limit Switch Retaining Bracket - Manual (Page 2)

HIRED-HAND, INC. · 1733 Co Rd 68 · Bremen, AL 35033 · Phone 1-800-642-0123 · Fax 205-287-2000
15. Align the limit switch cam by sliding it until both the top and bottom edges may be seen in the two
small holes in the new cover, then tighten set-screw. (See drawing below.)
Align edges of
cam block to
these two holes,
then tighten
setscrew.
16. Slide the bottom assembly into the machine.
17. Install the four bolts removed in step 4 back into the same holes.
18. Attach the quick connects from the motor, and limit switches.
19. Replace Door.
20. Connect power to the PowerTrak
21. Fully open then close the curtains, vents, or doors connected to the PowerTrak. Check that the motor
turns the right direction, and that the limit switches are functioning properly.