Hired-Hand Polar Cool: Pump & Float Replacement - Manual (Page 2)

ROLLSEAL, INC • 1751 Co Rd 68 • Bremen, AL 35033 • Phone 256-287-7000 • Fax 256-287-7010
9. Attach the pump to the hose and secure with the existing clamp.
10. Install the hose and pump to the inlet water supply.
11. Place the pump as shown so the pump is touching
the bottom of the PolarCool as shown in Figure 5.
12. Attach the pump bracket to the front cabinet using
the old mounting bolt and nuts.
13. Reconnect the electric pump cable to the junction
box that was removed in Step 3 above. See
Wiring Diagrams below.
14. Turn on system and check tightness of water hose
connections.
New
Pump
New
Float
Figure 4
NOTE: Pump will set in a wire filter
basket. Basket not shown above.
Bolts
New
Float
Figure 5
Pump
Bracket
New Pump