Alamo none - Manual (Page 99)

OPERATION
GRASS KING 03/09 Operation Section 4-13
© 2009 Alamo Group Inc.
OPERA
T
ION
4. Remove hex nuts, washers and carriage bolts
from bracket at each end of roller. Make certain
that roller bracket is free to move once the
fasteners are removed. A stuck roller could drop
unexpectedly and cause injury.
5. Use lifting device to reposition cutter housing to
desired cutting height. Align bracket holes with
cutter housing, then reinstall hardware.
6. Lower cutter housing to the ground and remove
lifting device.
7. Set cutting height according to procedures
above for remaining two cutter sections. Make
sure that all three rollers are set at the same
height to ensure an even cut across the entire
width of the mower.
Leveling Deck
To Facilitate a safe and efficient mowing
operation, the mower should be operated
parallel to the ground at all times. Never operate
if front or rear of mower is tilted upward. Objects
may be discharged at high speeds causing
possible injury or even death.
Adjust Top Link to level mower roller
adjustment. Side Skid Shoes should always be
parallel to ground throughout the full
adjustment range. Adjust cutting height of
machine by raising or lowering rear roller as
specified in Operation Section.
Do not let the Blades turn when the Mower Deck is raised for any
reason, including clearance or for turning. Raising the Mower deck
exposes the Cutting Blades which creates a potentially serious hazard
and could cause serious injury or even death from objects thrown from
the Blades.
(SRM-07)