Condec DLR334 - Manual (Page 7)

PAGE 7 74845
COMMAND CODE SUMMARY TABLE II
COMMAND RESPONSE D DESCRIPTION
OSR OSR {o1|o2} 3 Output status recall. :later
DISPLAY:
MPD ACK - Display to Max mode. ;later
MMD ACK - Display to Min mode. ;later
UNITS:
UxD ACK - Conv. Select units (x=A,B,C etc. per
Table III)
UUE {unit1| unit2} ACK 1 Base ‘Cal’ units entry.
UUR UUR {unit1|unit2} 3 Base ‘Cal’ units recall.
PRINT:
PRD ACK - Print to printer Port 2. ;later
CAPACITY:
CPE {cap} ACK 6 Capacity entry.
CPR CPR {cap} 6 Capacity recall.
REE {res} ACK 5 Resolution entry.
RER RER {res} 5 Resolution recall.
CALIBRATION:
ZCD ACK 6 Perform zero cal.
RxD ACK Perform linear reset at span x;
Where x is a # from 1 – 9 or letter
‘a’.
HCE {data} ACK 166 Perform hysteresis correction.
LxE {data} ACK 6 Perform linear cal at point x; Where
x is a # from 1 – 9 or the letter ‘a’
(linear on).
ZFE {x1|c1} ACK 17 Zero cal correction entry.
ZFR ZFR {x1/c1} 17 Zero cal correction recall.
LXE {x1|---x9|xA} ACK 89 Span cal linear corr. All X’s entry.
LXR LXR {x1|---x9|xA} 89 Span cal linear corr. All X’s recall.
LFE {x1|---x9|xA} ACK 89 Span cal linear corr. All S’s entry.
LFR LFR {x1|---x9|xA} 89 Span cal linear corr. All S’s recall.
LCE {x1|---x9|xA} ACK 89 Span cal linear corr. All C’s entry.
LCR LCR {x1|---x9|xA} 89 Span cal linear corr. All C’s recall.
HFE {x1|c1} ACK 17 Hysteresis (X and C) corr. Entry.
HFR HFR {x1|c1} 17 Hysteresis (X and C) corr. Recall.
SETUP DATA:
SUE {d/s|---min} ACK 13
SUR SUR {d/s|---min} 13 Main pressure setup recall.
FLE {fil} ACK Filter setup entry.
FLR FLR {fil} Filter setup recall.
INE {I1|I2} ACK Input setup entry.
INR INR {I1|I2} Input setup recall.
P2E {s1|---s7} ACK Port 2 serial setup entry.
P2R P2R {s1|---s7} Port 2 serial setup recall.
TME {hhmm} ACK Time entry.
TMR TMR {hhmm} Time recall.
DTE {mmddyy} ACK Date entry.
DTR DTR {mmddyy} Date recall.
TIE {time/date} ACK Time and Date setup entry.