Condec DLR334 - Manual (Page 17)

PAGE 17 74845
DTE / DTR = Date.
DxE / DxR = Temperature Corrections entry and recall (x=1 or 2)
FLE / FLR = Filter setup.
HCD = Perform Hysteresis cal.
HFE/HFR = Hysteresis correction.
HNE/HNR = RPM/HP setup data.
HxD = Span Temp Hot Acquire.(x=X,Y or Z).
HxD = Zero Temp Hot Acquire (x=1,2 or 3).
INE / INR = Input setup.
ISR = Input status.
LCE / LCR = Span Cal Linear corr. All C's.
LFE / LFR = Span Cal Linear corr. All S's.
LxE = Perform Linear Cal at point x; Where x is a # from 1 - 9 or A
LXE / LXR = Span Cal Linear corr. All X's.
MGD = Display to pressure mode. ;later
MMD = Display to min mode. ;later
MND = Display to net mode. ;later
MPD = Display to max mode. ;later
MSR = Unit/mode status
OSR = Output status.
PAE/PAR = Parallel I/O setup.
PDR = Display data.
PGR = Pressure data.
PHR = HP data
PMR = Min data.
PNR = Applied tare. ;later
PPR = Max data.
PRD = Print to printer port 2.
PSR = Pressure status (motion, etc).
P2E / P2R = Port 2 serial setup.
REE / RER = Resolution.
RSD = Span temp reference acquire.
RxD = Linearization Reset (x = 1-9 or A)
RZD = Zero temp reference acquire.
SUE/SUR = Main Pressure setup.
TAD = Tare. / is function of motion etc. :later
TFR = Temperature reading.
TIE/TIR = Time and Date setup.
TME / TMR
= Time.
TNE / TNR = Setpoint (Trip Point) setup
TPD = Temperature cal on.
TRD = Temperature reset.
TXD = Temperature cal off.
TxR = Temperature disgnostic recall (x=1,2 or 3)
UUE/UUR = Base ‘cal’ units config
UxD = Select units
ZCD = Perform Zero Cal.
ZED = Zero.
ZFE / ZFR = Zero cal correction.