Condec DLR334 User Manual
Page 10
PAGE 10
74845
T
Temp
D
Diagnostic ;later
! Pressure status (PSR command)
DATA FORMAT:
LENGTH:
Fixed at 1 character
WHERE:
stat: one character data field;
I
= invalid data
O
= over range
U
= under range
M
= motion
C
= center of zero
'Sp'
= none of the above
! Input status (ISR command):
DATA FORMAT:
LENGTH:
Fixed at 3 characters
WHERE:
i1 = input 1 status
i2 = input 2 status
0 represents an open input (logic 1)
1 represents a closed input (logic 0)
| = seperation character.
! Output status (OSR command):
DATA FORMAT:
LENGTH:
Fixed at 3 characters
WHERE:
o1 = output 1 status
o2 = output 2 status
0 represents an open output (logic 1)
1 represents a closed output (logic 0)
| = separation character.
11.0 CAPACITY/RESOLUTION ENTRY AND RECALL:
! COMMANDS:
CPE{} / CPR
= Capacity.
REE{} / RER
= Resolution.
! Capacity DATA entry (CPE{} command) and recall (CPR command):
DATA FORMAT:
LENGTH:
Fixed at 6 characters.
WHERE:
data:
Six (6) character data field with no polarity and decimal point.
-Entry with or without leading zero blanking.
-Recall with leading zero blanking.
! Resolution DATA entry (REE{} command) and recall (RER command):
DATA FORMAT:
LENGTH:
Fixed at 5 characters.
WHERE:
data: Five (5) character data field including decimal point when required.
-On Entry and Recall, if a decimal point is included then use full
leading zeros; if no decimal point is included then begin data with
a space followed by leading zeros.
12.0 BASE UNITS ENTRY AND RECALL:
! COMMANDS:
UUE{}/UUR
= BASE UNITS ENTRY AND RECALL