Condec DLR334 - Manual (Page 14)

PAGE 14 74845
14.8 TIME/DATE SETUP:
COMMAND: TIE/TIR
DATA FORMAT: ||
LENGTH: Fixed at 5 characters.
WHERE: (all codes fixed at one (1) number code; see code table below)
t1 = 12 hour or 24 hour select.
t2 = Date format select.
t3 = Date number or letter select
TIME/DATE PARAMETER ASSIGNMENT
CODE# T1 T2 T3
0 24 HR MM/DD/YY NUMBER
1 12 HR DD/MM/YY LETTER
14.9 PARALLEL SETUP:
COMMAND: PAE/PAR
DATA FORMAT:
LENGTH: Fixed at 1 character.
WHERE: par: code fixed at one (1) number code; see code table below
CODE # PARALLEL PARAMETER ASSIGNMENT
CODE# MODE
0 Parallel OFF
1 Parallel ON
14.10 ANALOG SETUP :
COMMAND: ANE{}/ANR
DATA FORMAT: ||||||
LENGTH: Fixed at characters.
WHERE:
anlg 1 = Analog Option select.
anlg 2 = 10 or 5 volt output
anlg 3 = Select type of data for the analog output.
zero = Zero offset entry.
fs = Full scale entry.
zr adj = Zero adjust entry.
sp adj = Span adjust entry.
CODE # / PARAMETER ASSIGNMENT
CODE# anlg 1 anlg 2 angl 3 Zero f s zr adj sp adj
0 ANLG OFF 10
volts
PRESSURE xxxxxxx
x
xxxxxxx
x
xxxxxxxx xxxxxxx
x
1 ANLG ON 5 volts DELTA T
14.11 SETPOINT (TRIP POINT) SETUP:
COMMAND: TNE{}/TNR
DATA FORMAT: |||||||||
|||||||||
||
LENGTH: Fixed at characters.
WHERE: