Brocade ICX 6450-C Compact Switch Hardware Installation Guide - Manual (Page 27)

1 Rack-mounting screws
2 Cage nuts
FIGURE 10 Installing the device in a two-post rack
6. If installing a single device only, proceed to the “Powering on the system” section. If installing
multiple devices, mount them in the rack, one below the other.
Wall mount installation
Use the following items to wall mount the device directly to a wall:
• #2 Phillips screwdriver
• Hammer
• Drill
• Wall mount anchors
• Wall mount screws
• Wall Mount Holes Location template
• tape
To mount the device to a wall using the wall mount brackets, see Wall mount installation using wall
mount brackets on page 28.
NOTE
When mounting the device on a wall, Brocade recommends that you mount the device with the port side
down.
Complete the following steps to mount the device directly to a wall. Refer to the two figures below.
1. Use tape to place the Wall Mount Holes Location template against the wall, in the same position
that you plan to place the device against the wall. The Wall Mount Holes Location template serves
Wall mount installation
Brocade ICX 6450-C Compact Switch Hardware Installation Guide 25
53-1003081-01