Brocade ICX 6450-C Compact Switch Hardware Installation Guide - Manual (Page 12)

• Console management interface (RJ45 serial port)
• Out-of-band management interface (RJ45 port)
• Reset button
These RJ45 management ports are located together on the left side of the front panel as shown in the
figure below.
1 Console port
2 Slot 1 (10/100/1000 Mbps ports)
3 Slot 2 (Copper uplink and PD ports)
4 Slot 3 (SFP uplink ports)
5 Out-of-band management port
6 Reset button
FIGURE 3 Management interfaces on an ICX 6450-C12-PD device
Console management interface
The console management interface is an RJ45 serial port that allows you to configure and manage the
device using a third-party terminal emulation application from a directly connected PC.
Out-of-band management interface
The out-of-band management interface is an RJ45 port that allows you to configure and manage the
device from the network.
Reset button
The reset button allows you to restart the system without switching the power supplies off and on or
using the CLI. When the reset button is pressed, the system resets and the software is reloaded. The
button is directly below the power LED on the very left of the device’s front panel.
Network interfaces for an ICX 6450-C device
An ICX 6450-C device contains the following interfaces:
• 12 10/100/1000 BASE-T RJ45 copper connectors (Slot 1, Ports 1- 12)
‐ Ports 1- 4 are dedicated PoE/PoE+ ports.
‐ Ports 1- 4 are MACSec-ready.
• 4 100M/1G ports:
‐ 2 10/100/1000 BASE-T, RJ45 ports (Slot 2, ports PD1/C1-PD2/C2); can be used as
uplink or PD ports
‐ 2 100M/1G SFP uplink ports (Slot 3, ports F1-F2)
Console management interface
10 Brocade ICX 6450-C Compact Switch Hardware Installation Guide
53-1003081-01