Brocade Mid-Mount Rack Kit (Switch) Installation Procedure (Supporting 300, 5100, 5300, 6505, 6510, 6520, 7800, 8000, VA-40FC, VDX 6710-54, and VDX 6740) - Manual (Page 9)

Mid-Mount Rack Kit (Switch) Installation Procedure 9 of 10
53-1001273-07
Attaching the rear brackets to the rack
NOTE
Do not use the rear brackets for the Brocade 6505, 6510, or 6520 switches.
Complete the following steps to attach the rear brackets to the rack.
1. Position the right rear bracket in the right rear of the switch ( Figure 4 ).
2. Attach the brackets using three 10-32 x 5/8-in. screws and 10-32 retainer nuts.
3. Repeat step 1 and step 2 to attach the left rear bracket.
4. Adjust the brackets to the rack depth and tighten the screws to a torque of 25 in-lbs (29 cm-kgs).
FIGURE 4 Attaching the rear brackets to a rack
1 Bracket, front right 3 Screw, 10-32 x 5/8-in., flathead Phillips
2 Retainer nut, 10-32 4 Bracket, rear right
4 3 2 1