Brocade Mid-Mount Rack Kit (Switch) Installation Procedure (Supporting 300, 5100, 5300, 6505, 6510, 6520, 7800, 8000, VA-40FC, VDX 6710-54, and VDX 6740) - Manual (Page 8)

8 of 10 Mid-Mount Rack Kit (Switch) Installation Procedure
53-1001273-07
Attaching the switch to a rack
Complete the following steps to install the switch in the rack.
1. Position the switch in the rack ( Figure 3 ), providing temporary support under the switch until the rail kit is
secured to the rack.
2. Attach the right front bracket to the right rack rail using three 10-32 x 5/8-in. screws and three 10-32 retainer
nuts.
3. Attach the left front bracket to the left rack rail using three 10-32 x 5/8-in. screws and three 10-32 retainer
nuts.
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs (29 cm-kgs)
FIGURE 3 Attaching the switch to a rack
1 Bracket, front right 3 Retainer nut, 10-32
2 Screw, 10-32 x 5/8-in., panhead Phillips
3 2 1