Anthro Elevate Original Single Surface Assembly Instructions - Manual (Page 5)

Elevate, TM Electric Lift Table Assembly Instructions 5
STEP 5
Install Keypad and Control Box
¡ Select positions for the Keypad and Control Box,
either the left or right side of the Table. Remember
that the Keypad and Control Box must be on the same
side of the Table. Also, the power cord comes off the
back of the Control Box and should be positioned so
it can reach the outlet.
¡ Place the Control Box on the shelf so that the cord
outlets are at the back, then align the Box with the
pre-drilled holes on the shelf. Secure with four Wood
Screws.
¡ Align the Keypad and its housing with the four pre-
drilled holes at the front of the keyboard surface so
that the buttons are face-down at the front edge of
the keyboard surface and the flat side of the housing
is against the shelf. Using four Phillips Head Screws,
attach the Keypad and its housing to the front of the
keyboard surface.
¡ Route each leg cord from the leg to the control box
and plug them in. Insert cable clips into the table and
route leg cords through them. Plug the keypad cable
into control box. Insert a cable clip into the table and
route the cord through it.
STEP 6
Attach Cable Trough
¡ Align the cable trough with the flanges on each leg
gusset and the pre-drilled holes on the shelf. Before
installing the trough, make sure that cables are routed
through the ends of the trough, not into the side of
the trough. Secure the trough to the gussets with four
Button Head Cap Screws. Secure the trough to the
shelf using eight Wood Screws.
STEP 7
Add Casters and Turn Table Right Side Up
¡ Thread casters into the caster inserts in each leg. This
is a lot easier if you lock the casters first.
¡ With the help of another person, carefully rotate the
Table onto its casters.
¡ Plug the power cord into the control box and an
outlet. Insert a cable clip into the base tube closest to
the Control Box and route the power cord through it.
3/4" Wood Screw
325-5106-00
1-1/4" Wood Screw
325-5178-00
3/8" Button Head Cap Screw
325-5149-00
Cable Trough
3/4" Phillips Head Screw
325-5370-00
Keypad Detail
Cable Snap-in Clip
175-51188-00
Cable Snap-in Clip
175-51188-00