PrehKeyTec GmbH - Manual (Page 9)

Advanced Programming
Advanced Programming - Creating a new customized layer
If you have the need to create a new or modified layer, just follow these steps below. In this example we create a
layer which is active as long as both AND are pressed.
Select menu Configuration
→
Layer Definition , and then you will get a dialog like this:
1. First select the tab New Layer and
enter a name for the new layer
2. Configure the Modifiers / More
Modifiers to program when this new
layer should be active
3.
Select when the programmed
sequences should be output (usually:
key press only)
4. Adjust the layer default attributes, for
example Key Click
5. After OK you will be asked if the
settings should be stored for future
use – please see notes below.
Now you can place key assignments on
this new layer like on the pre-defined
layers Normal, Shift, etc.
Figure 10
Notes on the dialog Configuration
→ Layer Definition:
• The modifiers / more modifiers checkboxes have the following meaning:
MUST NOT be active / pressed
MUST be active / pressed
IGNORE if this level is active or not
• To completely remove the user-defined layer, just open the Layer definitions dialog once again, mark and
delete the layer's name and press OK. Attention: All the assignments made on this layer also will be deleted!
• The
attributes MakeBreak and No Restore usually should stay not marked.
• A detailed description can be found in the Online-Help index, topic Layer Definitions.
Storing the layer settings
Layer settings are stored inside the start configuration file preh.ini. This will help to use customized layer settings
for your different keyboard layouts.
After changing the layer settings you will be asked if the modifications also should be saved in the start
configuration. Select yes, if this should be saved for future use. Otherwise changes just will apply to actual
session and the current layout.
Menu File
→
Default configuration will reset the start configuration to the WinProgrammer’s default configuration.
To use this function you first have to close all opened layouts.
PrehKeyTec GmbH Quickstart WinProgrammer - Apr 01 2011 Page 9/22