Stuart Turner Techflo TP 60TNH - Manual (Page 19)

- 19 -
Cont ...
Techflow Products reserve the right to amend the specification in line with its policy of
continuous development of its products.
Note: For information on other voltages/frequencies which are not shown, consult any
supplementary instruction sheet supplied, or the rating label attached to the
pump.
*Note: Max working pressure is the maximum pressure that can be applied to the
pump internal casing under any installation conditions.
**Note: In normal circumstances the temperature of stored water should never exceed
65°C. A stored water temperature of 60°C is considered sufficient to meet all
normal requirements and will minimize deposition of scale in hard water areas.
Maximum permissible water temperature 65°C.
7.11 Noise: The equivalent continuous A-weighted sound pressure level at a distance
of 1 metre from the pump does not exceed 70 dB(A).
7 TECHNICAL SPECIFICATION
Model TP60 SNH TP60 TNH
Electrical
Power supply
Volts/phase frequency
230/1/50 230/1/50
Enclosure IP22 IP22
Type of motor Induction Induction
Power consumption 280 Watts 440 Watts
Full load current 1.2 Amps 1.9 Amps
Rating
Int (S3) 30 mins on/30
mins off @ 9 l/min Int (S3) 30 mins on/30
mins off @ 9 l/min
Max. No Starts per hour 60 60
Mechanical
Max inlet head 6 metres 6 metres
Max head (closed valve) 26 metres 18 metres
Max working pressure* 380 kPa (3.8 bar) 380 kPa (3.8 bar)
Max ambient air temperature 40 o C 40 o C
Max water temperature** 65 o C 65 o C
Min water temperature 4 o C 4 o C
P
ump
Dimensions
Length 233 mm 305 mm
Width 139 mm 139 mm
Height (excluding flexible hoses) 338 mm 338 mm
Gross Weight (packed) 5.6 Kg 6.5 Kg
Pump Connections: Inlet G ¾ Male G ¾ Male
Outlet G ¾ Male G ¾ Male
Flexible Hose G ¾ x 15 mm Push-in G ¾ x 15 mm Push-in