Stuart Turner Showermate U1.8 bar Twin - Manual (Page 12)

- 12 -
Cont ...
2. Prior to inserting pipe into fitting, mark the insert depth on the wall of the pipe
with a soft pencil at a distance of 31 mm from the end to be inserted (Fig. 10).
3. Check in the mouth of the fitting that the ‘O’-ring, nylon washer and collet
are in position as shown in Fig. 11.
4. Push the pipe firmly into the fitting, until pencil mark is level with the top
of the collet and the pipe stop resistance is felt. Pull on the pipe to check it is
secure and correctly fitted
5. To release the joint, push pipe firmly into the fitting, hold the collet down and
gently remove pipe. If the system has been filled with water care should be
taken to isolate the pump and towels used to absorb spilled water.
Fig. 10
15 mm Pipe
Pencil
Mark
Insert Depth 31 mm
Fig. 11
Collet
Washer
‘O’-Ring
Flexible Hose
Pipe Stop