Mounting the lathe – MAHLE RTI BRC40 User Manual
Page 12
RTI
RTI
RTI
RTI
TECHNOLOGIES, INC.
TECHNOLOGIES, INC.
TECHNOLOGIES, INC.
TECHNOLOGIES, INC.
Page 11
Figure 3 Hang the Lathe
Figure 4 Mounting the Lathe
Figure 5 Positioning the Lathe
MOUNTING THE LATHE
6.
Place Twin Cylinder Mounting
Brackets on each of the Adapters
mounted in the preceding step.
Do not tighten the Allen Socket
Bolts in the Mounting Brackets.
7.
Hang the Lathe on the lower Twin
Cylinder Mounting Bracket as
shown in Figure 3.
8.
Swing the Lathe upwards and
slide the top Twin Cylinder
Mounting Bracket onto the Lathe
mounting bracket. See Figure 4.
9.
Position the Lathe so that the
Lathe centerline is slightly below
the center of the wheel hub and
the brake rotor is centered
between the side plates of the
Lathe. Refer to Figure 5.
10. Tighten Allen Socket Bolts in both
Twin Cylinder Mounting
Brackets.
- NTO-200 (REV A) (16 pages)
- NTO-200 (7 pages)
- NTF-15H (1 page)
- NTF-15H (11 pages)
- NTF-230 (13 pages)
- NTF-230 (Rev B) (11 pages)
- NTF-15 (10 pages)
- NTF-15 (11 pages)
- NTF-515 (Rev A) (14 pages)
- ATX-2 (Rev B) (15 pages)
- ATX-2 (Rev B) (17 pages)
- ATX-2 (Rev C) (15 pages)
- ATX-2 (Rev D) (17 pages)
- ATX-2 (15 pages)
- ATX-2 (17 pages)
- ATX-2 (18 pages)
- ATX-2 (Rev A) (17 pages)
- PSX-2 (2 pages)
- ATX-3 (22 pages)
- MCX-1 (Rev A) (16 pages)
- MCX-1 (Rev D) (18 pages)
- MCX-1 (Rev E) (18 pages)
- MCX-2 (Rev A) (18 pages)
- MCX-2 (Rev B) (20 pages)
- MCX-2 (Rev C) (20 pages)
- MCX-2 (Rev D) (20 pages)
- MCX-2 (Rev E) (20 pages)
- MCX-2 (18 pages)
- MCX-2 (Rev F) (21 pages)
- MCX-2 (Rev F) (20 pages)
- MCX-2 (Rev G) (20 pages)
- MCX-2F (Rev A) (21 pages)
- MCX-2F (Rev C) (21 pages)
- MCX-2F (21 pages)
- MCX-2F (Rev D) (21 pages)
- MCX-2HD (20 pages)
- VCX-1 (16 pages)
- VCX-1 (17 pages)
- VCX-4 (17 pages)
- PSX-3 (1 page)
- DFX-1 (1 page)
- BFX-2 (12 pages)
- BFX-2 (13 pages)
- DCS-1 (2 pages)
- ELF-1 (14 pages)