MAHLE RTI MCX-1 (Rev D) - Manual (Page 15)

Page 14
Do not leave the MCX-1 unattended while emptying the waste tank.
The pump will be destroyed if allowed to run for more than one
minute after waste tank is empty.
Bulk Waste Container
Black Hose
Green Hose
OFF
& O VER FLO W
LO WE R R ADIA TOR
OFF
EXC HAN GE C OO LAN T O R
FILL RA DIA TOR & O VER FLO W
& O VER FLO W
LOW ER R ADIA TOR EM PTY WA STE TAN K
EXC HAN GE C OOL ANT & O VER FLO W
FILL RA DIAT OR
OFF
EMP TY W AST E T ANK
EXC HAN GE C
OO LAN T O R
FILL RA DIA TOR & O VER FLO
W
& O VER
FLO W
LOW ER R
ADIA
TOR EM PTY WA STE TA NK
OFF
OFF
& O VER FLO
W
FILL RA DIA TOR
EXC HAN GE C
OO LAN
T
EM PTY
WA STE TAN K
& O VER FLO W
LOW
ER R
ADIA TOR
OFF
EMPTYING THE WASTE TANK
The Waste Tank can be emptied two different ways.
A. The Waste Tank can be removed from the MCX-1 and transported to the area
where it is to be emptied. A quick connect coupler is installed on the black hose
to make this disconnection quick and clean.
B. The MCX-1 can be used to pump the waste coolant directly from the Waste
Tank into another waste collection tank. A 12 volt battery will be required to
power the MCX-1.
1. Install the Wand on the black hose.
2. Turn control valve to EMPTY WASTE TANK.
3. Press the top of the EMPTY WASTE TANK selector switch to start the pump.
4. Hold the Wand over the Bulk Waste Container and open the valve.
5. Waste coolant will be pumped directly from the MCX-1 Waste Tank into the
Bulk Waste Container.
6. Close the valve on the Wand immediately after waste tank is emptied.
7. Press the bottom of the EMPTY WASTE TANK selector switch to stop the
pump.