Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 5)

5
IM 04L31A01-05E
Setup Procedure
1. Use the arrow keys to move the cursor (blue) to the [Event output setting] box.
A soft key menu is displayed at the bottom of the display.
2. Press the [Common] or [Separate] soft key .
The box for the item you changed turns yellow, and the cursor moves to the next
item.
3. Press the DISP/ENTER key to confirm the changes.
The boxes for the items you changed turn from yellow to white, and the cursor
returns to the first item box.
Saving the Settings
1. Press the ESC key .
The display returns to the basic setting menu.
2. Press the [End] soft key .
A window appears for you to confirm the saving of the new settings.
3. Select [Yes] and press the DISP/ENTER key .
The operation screen is displayed.
Event Output Setting in Setting Mode (Control)
If you selected [Separate] in the Event output setting in Basic Control Settings, carry out
the procedure below to set the [Pattern number] box to a program pattern number
between [1] and [30].
For a description of the settings other than [Pattern number], see section 5.7, “Program
Pattern Settings > Event Output Settings” in the DAQSTATION CX2000 User’s Manual
(IM 04L31LA01-01E) or the DAQSTATION CX1000 User’s Manual (IM 04L31LA01-03E) .
Opening the Setting Display
On the CX2000
Press the keys in the following sequence:
MENU key (switch to the setting mode (control)) > #7 soft key (select [Program-
control parameters]) > #2 soft key (select [Event output setting])
From the operation display, use the above keys to open the following display.
• If you selected [Common] for Event output setting in Basic Control Settings
Operations on the CX1000/CX2000