Yokogawa Value Series FX1000 - Manual (Page 11)

10
IM 04L21B01-02EN
Names of Parts
Front View
Operation cover opened
LCD
Display various operation displays
such as the trend display as well as
setup displays.
USB port
(/USB1 option)
A USB port conforming to
Rev. 1.1.
Operation cover
Open the operation cover by pulling
the cover while holding down the tab
at the center of the upper section of
the cover.
When closing the front cover, press the front cover in until the tab at the center of the upper section of the cover
is all the way up. If the front cover is not closed completely, the water and dust proof capability may be impaired.
If the rubber packing slipped, attach it so that the ribs come to the downside, as shown in the figure. The dust and
water protection is not guaranteed if it is attached upside down. Attach it firmly, depressing the rib lightly with a finger.
CF card slot
On FXs that have a CF card slot
(suffix code -4.)
CF card eject button
Used when ejecting the CF card.
Label (front of the operation cover)
You can attach a label to the front of the operation
cover. You must print the label yourself.
CAUTION
Ethernet port
(/C7 option)
A 10Base-T port.
Optional terminals (/A[ ], /A4A,
/C3, /F1, /R1, /TPS[ ], and /PM1
options)
Used to connect optional
input/output signal wires.
Power supply terminals and
a protective earth terminal
Serial port (/C2 option)
RS-232 port.
Input terminals
Used to connect input signal
wires from the item you want to
measure.
Rear Panel
Operation cover opened
LCD
Display various operation displays
such as the trend display as well as
setup displays.
USB port
(/USB1 option)
A USB port conforming to
Rev. 1.1.
Operation cover
Open the operation cover by pulling
the cover while holding down the tab
at the center of the upper section of
the cover.
When closing the front cover, press the front cover in until the tab at the center of the upper section of the cover
is all the way up. If the front cover is not closed completely, the water and dust proof capability may be impaired.
If the rubber packing slipped, attach it so that the ribs come to the downside, as shown in the figure. The dust and
water protection is not guaranteed if it is attached upside down. Attach it firmly, depressing the rib lightly with a finger.
CF card slot
On FXs that have a CF card slot
(suffix code -4.)
CF card eject button
Used when ejecting the CF card.
Label (front of the operation cover)
You can attach a label to the front of the operation
cover. You must print the label yourself.
CAUTION
Ethernet port
(/C7 option)
A 10Base-T port.
Optional terminals (/A[ ], /A4A,
/C3, /F1, /R1, /TPS[ ], and /PM1
options)
Used to connect optional
input/output signal wires.
Power supply terminals and
a protective earth terminal
Serial port (/C2 option)
RS-232 port.
Input terminals
Used to connect input signal
wires from the item you want to
measure.