Yokogawa EJX530B - Manual (Page 47)

<8. Setting Parameters>
8-14
IM 01C27F01-01EN
(b) Detachable antenna type (Amplifier housing code: 8 or 9)
• UAPMO
• TRANSDUCER
• AI1 DP
• AI2 SP
• AI3 Temp
• Device Configuration
• Diagnostic
• Process Variable
(Device Configuration) Menu (Online)
F0803-4.ai
• Configure/Setup
(UAPMO)
• Configure/Setup
(TRANSDUCER)
• UAP Option
• Hardware Write Protect
• Static Revision
• Reset Energy Left
• Radio Silence
• Energy Harvest Type
(Configuration)
• Version Revision
• CTS Version
• ITS Version
• Identification Number
(Identification)
• Auto Recovery
• Model
• Sensor Serial Number
• Measurement Rate
• Measurement Mode
• Wireless Status
• Display Selection
• LCD Mode
• Special Order ID
• Unit Sel1
• Display Unit1
• LCD Intermittent Time
• XD Filter
• EJX Key
• Test Key 1
• Test Key 2
• Test Key 3
(Configuration/Calibration)
• Tag Description
(Block Info)
• Configure/Setup
(AI1 DP)
• Mode.Target
• Mode.Actual
• Mode.Permitted
• Mode.Normal
(Block Mode)
• Block Mode
• Concentrator OID
• Scale *
• Process Value Filter Time
(Configuration)
• Block Mode
• Cal Cmd *
• Cal Status
• Calibration Highest Point
• Set Calibration Highest Point *
• Calibration Lowest Point
• Set Calibration Lowest Point *
• Calibration Minimum Span
• External Zero Trim *
(Calibration)
• Mode.Target
• Mode.Actual
• Mode.Permitted
• Mode.Normal
(Block Mode)
• Upper Limit
• Lower Limit
• PV Range *
• Linerization Type *
• Flow Constant *
• Lower Cutoff
• Low Cut Mode *
• H/L Swap *
• T Zero Cmp *
• Temp Zero *
• Temp Select *
(Others)
• PV Range.EU at 100% *
• PV Range.EU at 0% *
• PV Range.Units Index *
• PV Range.Decimal*
(PV Range)
• Mode.Target
• Mode.Actual
• Mode.Permitted
• Mode.Normal
(Block Mode)
• Scale.EU at 100% *
• Scale.EU at 0% *
• Scale.Units Index *
• Scale.Decimal *
(Scale)
• Tag Description
(Block Info)
• Special Cmd
(Others)
• Other Faults Alert
• Faults Non-compliance
Alert
• Faults Process Influence
Alert
• Simulation Active Alert
• Soft Update Incomplete
Alert
• Power Low Alert
• Power Critical Low Alert
• Fault Prediction Alert
• Environmental
Conditions Alert
• Outside Sensor Limits
Alert
• Out of Service Alert
• Calibration Problem
Alert
• Faults Sensor or
Actuator Alert
• Faults Electronics Alert
(Alerts)
*: When the data of these parameters is rewritten, it is necessary to set the operational mode of the block to O/S (Out of Service).