Watlow Series 945, 1/4 DIN Microprocessor-BasedAuto-tuning Control - Manual (Page 14)

Setup, Chapter 4 14
WATLOW Series 945 User's Manual
Setup Menu
Figure 31 -
The Setup Menu
NOTE:
The rL and rH
parameters are used
to scale the display
for process inputs,
and/or will scale the
retransmit range for
process output. rL
and rH also limit the
range of the set
point.
= Parameter may or may not appear
depending on control configuration.
= Only appear if your unit has com-
munications. See the Series 945
data communications manual for more
information on these parameters.
M
LOC
In
dEC
C _ F
rL
rH
Ot 1
HYS1
Ot 2
HYS2
AL 1
LAt1
HYS3
AL 2
LAt2
HYS4
SIL
rtd
bAUd
Prot
Addr
Log
Int
tAg
( )
( )
( )
( )
( )
( )
( )
( )
( )
( )
( )
( )
( )
( )
( )
( )
( )
( )
( )
( )
( )
( )
( )
( )
75
( )
dAtA
rSP ( )
LSL
USL
LinE
Mon
dAY
HOUr
( )
( )
( )
( )
( )
( )
( ) YEAr
Min ( )
[Set Point]
User lock out
Input type
Remote set point
Decimal place
Celcius_Fahrenheit
Range low
Range high
Output 1
Hysteresis 1
Output 2
Hysteresis 2
Alarm 1
Latching for alarm 1
Hysteresis 3
Alarm 2
Latching for alarm 2
Hysteresis 4
Silence alarm
RTD calibration curve
Baud rate
Data bits and parity
Protocol type
Address
Logging printout
Lower spec limit
Upper spec limit
Lines per page
Current year
Current month
Current day
Real time hour
Real time minutes
Time interval
Variables to transmit
Ot4 ( )
Output 4
tbS ( )
Time base
Setup Parameters
When you are at the top of the menu, the Series 945 displays the user level of
operation in the upper display, and the LOC parameter in the lower display.
Press the MODE key and the value of the next parameter appears in the upper
display, the prompt appears in the lower display. For units with process input, see
the L-r parameter on Page 20 for how LOC is affected.
Lock: Selects the level of operator lockout. Range: 0 - 3 Default: 0
LOC 0: All operating parameters may be viewed or changed. Manual operation is
permitted. Bumpless transfer to manual operation can occur on sensor break.
LOC 1: The set point, actual, and L-r (if rSP is enabled) are the only visible parameters,
set point is adjustable in this level. Manual operation is permitted. Bumpless
transfer to manual operation can occur on sensor break.
LOC 2: The set point, actual, and L-r (if rSP is enabled) are the only visible parameters,
set point is adjustable in this level. Manual operation is not permitted.
Bumpless transfer is defeated, outputs are disabled on sensor break.
LOC 3: The set point and actual are the only visible parameters, set point is not
adjustable in this level of lockout. Manual operation is not permitted. Bumpless
transfer is defeated, outputs are disabled on sensor break.
LOC