Learn the software map, Software map; learn, Software organization – Watlow Series 935A User Manual

Page 11: Navigation example, Ot2] [disp] [alty, Display, Operations, Configuration

Watlow Series 935A User’s Manual

Software Organization

•

The Series 935A has three primary menus in addition to a normal display.

•

The software reverts to the normal display after 60 ± 5 sec.

Table 3 - Software Organization

•

At the

[`pid]

[Cnfg]

prompt, press and hold the

key, and the

key to select

[`yes]

. Release the keys to

move to the new menu.

Navigation Example

Learn the Software Map

Display

Actual Temperature, Set Point, or Time Remaining

Operations

, p. 10

Start / Stop:
•Autotune
Set:
•Alarm Ranges
•Countdown Timer
•Idle after Timer
Select
Set Point Type:
Go to:
PID Menu
Configuration Menu

PID

, p. 12

Set:
•Heat PID Functions
•Dead Band
•Cool PID Functions
•Calibration Offset

Configuration

, p. 16

Set:
•Inputs / Functions
•Output Types
•Display Default
•Alarms / Functions
•Timer Functions
•Failure Mode
•Lockout Functions

[`yes]

• To access the Operations Menu, press the

and

keys simultaneously for three seconds.

• Move through each menu with the

key.

• Make changes by pressing and holding the

key, and

then the

key to select a new choice or

value. Release the keys to complete the change.

• To exit any menu: Press and hold the

and

keys for three seconds,

or
the display will revert to normal display
after 60± 5 seconds.

[Prnc] [Prno [dEnc [dEno

[`Ot2]

[disp]

[Alty]