Proface APL3000B - Node Box PC - Manual (Page 21)

PS-3000B Series Hardware Manual
1-8
J: Ethernet Interface (LAN1)
10BASE-T/100BASE-TX Auto Changeover.
This interface uses an RJ-45 type modular jack connector (8 pins).
K: USB Interface (USB)
4 ports. USB 2.0 compatible. Uses a “TYPE-A” connector.
L: Analog RGB Interface
A mini D-sub 15 pin (socket) is used to connect a RGB monitor on the market or FP Series unit manufactured
by Pro-face.
M: Secondary CF Card Interface
Open the cover and insert the CF Card.
CF Card (Type I/II-compliant) is available. IDE-type connection.
*1
N: Primary CF Card Interface
Open the cover and insert the CF Card.
CF Card (Type I/II-compliant) is available. IDE-type connection.
*1
O: Power LED / RAS Status Lamp (ON)
P: HDD / IDE Access Lamp (DISK)
Power supply voltage 5 VDC ±5%
Output current
Each port: 500mA (max.),
4 ports total: 500mA (max.)
Maximum communication
distance
5m
*1 Since an IDE-type connection is used, the unit is not hot-swappable. When inserting/removing the CF
Card, be sure that power is turned OFF.
LED PS-B Status
Green (lit)
Normal Operation
(power is on)
Green (blinking) Soft OFF state
Orange (lit)
System Monitor Error
RAS Error
Not lit Power is OFF
LED PS-B Status
Green (lit) Access to IDE.
Not lit Not access to IDE.
• When attaching peripheral units to the PS-B, be sure the PS-B’s power cord is
disconnected from the main power supply.