Proface PS4800 - 19 Panel PC" - Manual (Page 45)

PS-4700 Series (Atom Z510 Pre-installed Model) User Manual
45
Follow the steps shown below when installing the Industrial Personal Computer:
Step Action
1 Check that the gasket is correctly attached to the Industrial Personal Computer.
NOTE: When checking the gasket, avoid contact with the sharp edges of the
Industrial Personal Computer frame, and insert it completely into its groove.
2 Install the Industrial Personal Computer in the panel opening (see page 42).
3 Insert each installation fastener securely into the slots at the top, bottom, left and
right side of the Industrial Personal Computer:
The number of slots is screen size dependent:
z 14 slots for the 15" Industrial Personal Computer.
4 Insert each fastener in its corresponding slot as shown in the figure below:
5 Pull the fastener back until it is flush with the rear of the attachment hole:
6 Use a 2,5 hexagon head screwdriver to tighten each of the fastener screws and
secure the Industrial Personal Computer in place:
NOTE: To ensure a high degree of moisture resistance, use a torque of 0.5 N•m
(4.5 lb-in).
7 Ensure that the angle is tilted no more than mounting orientation requirements
allow (see page 42).