Important, Figure 5 – SaltDogg 92440SSA Series Under Tailgate Spreader User Manual

Page 5

CONNECT

CONNECT TO BATTERY

TERMINALS ONLY

CONNECT TO FUSE OR WIRE

IN FUSE PANEL CONTROLLED

BY IGNITION SWITCH

5 AMP MAX

CONNECT TO

CHUTE MOTOR

CONNECT TO CHAIN/ AUGER

GEAR MOTOR

CONNECT TO VIBRATOR

OPTIONAL

#3016944

#3016943

#0203700

#3016934

CONTROLLER

IMPORTANT

IMPORTANT Make sure all wires securely attached to
vehicle or spreader. Use wire ties and/or wire clamps
to attach wires. All excess wires must be rolled into
bungles and attached to vehicle or spreader.

Thoroughly clean battery terminals. Make sure battery
terminals have no tarnish or corrosion. DO NOT CONNeCT
WIRe HARNeSS TO DAMAGeD OR CORRODeD
TeRMINALS!
IT MAy ReSULT IN OveRHeATING, LOST POWeR AND
POTeNTIAL CONTROLLeR DAMAGe!
K. Connect the power cable directly to the battery.
l. Insure all functions of the controller are
working properly.
M. Observe auger moving in proper direction. If direction is
wrong reverse wires between Motor and Wire Harness.
n. Optional spot light (5 AMP max) can be installed on
spreader. Remove cap from single white wire. Connect light
to this wire and trucks frame.

ATTACH WIRE HARNESS TO LOWER

DOOR USING CLAMP HK1113 AND

WING NUT 3005723. LEAVE ENOUGH

WIRE SLACK TO PLUG CONNECTORS

TO GEAR MOTOR.

Figure 5