Installation instructions – SaltDogg SHPE1500 Series Electric Drive Poly Hopper Spreader v.1 User Manual

Page 2

13.5

2" x 4"

2" x 6"

FIT TO BOX

Fork Lift

Pass strap under forks. Attach
strap to tie down on opposite
side of spreader. Tighten strap.

Safety Precautions

WARNING

Observe the following Safety Precautions before, during and
after operating this spreader. By following these precautions
and common sense, possible injury to persons and potential
damage to this machine may be avoided.

1. Read this entire Owners Manual before operating this

spreader.
2. Read all safety decals on the spreader before

operating.
3. Check to make sure all safety guards are securely

mounted into place before operating this spreader.
4. Verify that all personnel are clear of the spreader spray

area before starting or operating this spreader.
5. Do not over-load your vehicle beyond payload limits. If

there are any questions, contact the vehicle manufacturer.
6. Do not adjust, clean, lubricate or unclog material jambs

without first turning off the spreader.
7. Do not climb on or in the spreader during operation. Do not

ride on the spreader while the vehicle is
in motion.
8. Make sure the spreader is securely fastened to the vehicle

in accordance with this manual.
9. Do not operate a spreader that is in need of maintenance

or repairs.
10. Always disconnect the battery before removing or

replacing electrical components.

Installation Instructions

1. Mounting the Spreader onto the Vehicle:
A. Remove the tailgate from the vehicle.
B. Check truck’s bed for all kinds of sharp debris or foreign

objects. They can cut and seriously damage poly hopper.
C. Lift spreader- See appropriate instructions below. Lift

spreader by tie downs - Fig. 1. Lift spreader using fork lift-
Insert fork into fork slots molded in spreader legs - Fig. 2.
Use fork extensions or strap spreader to fork lift as shown.

D. Slide spreader forward until step on spreader’s most rear

leg makes contact with truck’s bed.
E. Center the spreader from side to side on the vehicle.
F. Measure the distance from the front of the truck bed

to front of the hopper’s front legs. Fabricate spacer to fit
between front of the spreader and front of the bed per Fig. 3
and Fig. 4

Fig. 1

Fig. 2

Reinstall screen after removing chute and hardware box
from the hopper.

Always use screen during spreader operation!

Fig. 3

Use Tie Downs

Fig. 4