SaltDogg TGS01B Salt Spreader - Manual (Page 3)

Quality since 1946
3
8. Attach Adapter (3009863) to Socket Assembly
(0203200).
9. Connect Red motor wire to Red adapter wire and
Black motor wire to Black adapter.
10. Make sure Controller is OFF, start the truck.
11. Turn Controller ON. Adjust speed to desired
setting. Do not change speed abruptly! It may
stall motor.
12. Observe spinner direction of rotation. The cor-
rect direction is counter clock wise when looking
inside hopper from the top. If direction is clock
wise reverse wires between Motor and Adapter.
IMPORTANT
Make sure all wires securely attached to vehicle or
spreader’s frame. Use wire ties and/or wire clamps
to attach wires. All excess wires must be rolled into
bungles and attached to vehicle or spreader.
Spreader Maintenance
1. This spreader is designed to use loose free float-
ing materials such as #1 dry Rock Salt. Using differ-
ent grades and/or wet material will affect spreader
performance. Wet material can “bridge" and stop
floating onto spinner disk.
2. Make sure lid is installed and latches are
secured when spreader is in use.
3. Do not leave material in hopper between uses.
4. Do not drive with material in hopper.
5. Always clean/wash hopper at the end of the day.
6. Spray lubricant around motor shaft to prevent
water from penetrating into the motor.
7. Apply dielectric grease to all electrical connec-
tors between uses and for long term storage.
CAUTION
Do not attempt to install or remove spreader with
material in it.
Motor
3009476
Wire Assembly, Red 222"
0203600
Blue Wire
0203700
To Terminal Controlled
By Ignition Switch
Wire Assembly
To Battery
0203800
Black Wire
To Frame Or Battery
Negative Terminal
Adapter
3009863
Socket Assembly
0203200
To Truck Frame
Fig. 2