Ramsey Winch RPH-8000Y (JERR-DAN) - Manual (Page 14)

Before installing motor, check brake adjustment (refer to page 6, ADJUSTING THE
BRAKE).
Place splined end of coupling (item #32), with spirol pin (item #42) installed, inside of
motor end bearing housing (item #8) and slide over splines on end of input shaft. Place
o-ring (item #39) around motor pilot. Mount motor (item #36) to end bearing by aligning
key on motor shaft with keyway in coupling. Be sure that motor mounts flush to end bear-
ing and that o-ring is set securely in place between motor and end bearing. Secure motor
to end bearing using two capscrews and lockwashers (items #25 & #31). Tighten cap-
screws to 49 Ft.Lbs. (66 Nm). Thread plug (item #41) into bottom of brake housing.
Permatex can be added to threads of plug to help in sealing. Pour a mixture of 8 oz. of
Mobilfluid 424, Phillips HG Fluid, Texaco TDH, Shell Oil Co. Donax TD high performance
tractor transmission fluid, or equivalent and 1/4 oz. of an additive (available from the fac-
tory), into oil level hole. Oil level should be kept at oil level hole (plus or minus 1/8").
Thread plug (item #41) into oil level hole. Insert reducer (item #40) into hole in top of
brake housing and breather plug (item #35) into reducer. Tighten plugs and reducer
securely. Attach frame assembly (item #2) to winch using (8) capscrews (item #19).
12