beautypg.com

Ramsey Winch RPH-8000Y (JERR-DAN) User Manual

Page 10

background image

Remove tie plates (item #14) from end bearings (items #8 & #9) by unscrewing

capscrews (item #19), as shown. Slide motor end bearing (item #8) from drum (item #1)

and drum from gear housing end bearing (item #9). Remove input shaft (item #13) from

end bearing. Inspect teeth of gear (item #6) for signs of wear. If necessary replace gear

by removing snap ring (item #48) and thrust washer (item #51). Slide new gear over

splines of shaft and against snap ring on shaft. Re-install thrust washer and place snap

ring into groove of shaft.

8

See also other documents in the category Ramsey Winch For the car: