Ramsey Winch RPH-8000Y (JERR-DAN) - Manual (Page 12)

Remove o-ring (item #37) and bushing (item #16) from motor end bearing (item #8).
Press new bushing onto end bearing and dip o-ring in oil and seat into groove of end
bearing. Remove seal (item #46) from gear housing end bearing (item #9). Loosen nut
(item #28) and remove nylon setscrew (item #23) and remove ring gear (item #7) from
gear housing end bearing, if necessary. Remove bushing (item #18) from gear housing
end bearing (item #9). Press new bushing (item #18) into place in end bearing. Install
ring gear and nylon setscrew and nut. Ring gear must be fully seated in gear housing end
bearing (item #9) and slot in ring gear must NOT be aligned with clutch shifter hole. Install
new seal in gear housing end bearing, with sharp edge of seal outward.
10