Ramsey Winch RE 12000 OVERHAUL INSTRUCTIONS - Manual (Page 6)

6
18. Place thrust washer #66 over each end of spur gear shaft #20. Set spur gear shaft assembly into bearing
of spur gear housing. Slide gear #11 and thrust washer #66 over end of worm shaft.
Insert pins #55 into cover #7. Place gasket #42 onto cover. Attach cover and gasket to spur gear housing
using twelve capscrews #28. Torque capscrews to 8 ft lbs (10.8 Nm.) each.
Insert plug #52 into bottom of spur gear housing. Permatex may be applied to threads to help prevent oil
leakage.
19. Insert plug #52 into bottom of gear housing.
Permatex may be applied to threads to help
prevent leakage.
Pour 3/4 pint of EP 140 gear oil into housing
thru hole in top of housing. Insert relief fit-
ting #48 into reducer #51. Reducer should
then be placed into hole on top of gear hous-
ing. Tighten fitting and reducer securely
.
48
51
52
Remove reducer #51 and fitting
#48 from top of spur gear hous-
ing. Pour 1/2 pint of SAE 20
weight motor oil into spur gear
box. Replace reducer and fitting
into top of spur gear housing.
Tighten reducer and fitting se-
curely.
Attach solenoid assembly #2 to
gear housing. Use two cap-
screws #33 and three capscrews
#30 with three flatwashers #38.
Tighten capscrews to 7 ft-lbs
(9.4 Nm) each.
48
51
11
42
7
55
28
55
24
24
66
66
66
24
52
2
30
38
33
20
OH-914248-1110-A