Ramsey Winch RE 12000 OVERHAUL INSTRUCTIONS - Manual (Page 2)

2
4. Slide clutch housing #16 from end of drum shaft. Slide jaw clutch #6
from end of drum shaft.
Remove (2) keys #45 from keyways. A screwdriver can be used, at
notch, to aid in removal of keys. Once keys have been removed, drum
#9 and thrust washer #67 can be removed from drum shaft. Springs
#64 and disc #40 can also be removed.
5. Remove bearing cap #5 from gear housing by
unscrewing four capscrews #29. Remove worm
#23 and bearing #25 from gear housing. Use a
soft hammer to gently tap input end of worm and
drive worm and bearing from gear housing.
Once worm has been removed from housing,
bearing can be pressed from end of worm.
Check for signs of wear to worm #23 and bearing
#25. Replace if necessary.
6. Remove gear housing cover #8 from
gear housing #17 by unscrewing five
remaining capscrews #28. Place cap-
screws into two tapped holes of cover
and tighten. This will pull the cover
loose from gear housing.
Remove cover gasket #43 and pull
shaft #21, with gear attached, and
thrust washer #68 from gear housing.
68
45
6
16
45
5
41
25
23
29
25
68
43
8
28
21
17
9
67
40
64
64
40