Ramsey Winch RE 12000 OVERHAUL INSTRUCTIONS User Manual

Page 4

11. Check cover bushing #26 for signs of wear. Replace if necessary

by removing old bushing and pressing new bushing into place.

RE-ASSEMBLY

12. Check gears #10 & #11 of spur gear shaft assembly for signs of wear, replace if

necessary. Press old gears from shaft #20. Tap key #19 into keyway of shaft
#20. Press shaft through gears so that gears are centered on shaft and key.

13. Apply grease to end of shaft,

opposite gear. Apply grease to
bushing in gear housing #17.
Place greased end of shaft
through thrust washer #68 and
bushing in gear housing #17.
Place gasket #43 onto gear
housing cover #8. Apply
grease to gear end of shaft and
bushing in cover. Place cover
onto shaft and secure to hous-
ing with five capscrews #28 at
the five lower most holes.

14. Place winch, with gear housing cover

down, on work bench. Drum shaft
should be in vertical position. Slide
thrust washer #67 over drum shaft and
slide downwards until washer rests on
gear housing. Set springs #64 and drag
brake disc #40 into pockets of gear
housing. Grease bushings in drum #9
Slide drum assembly onto drum shaft
with drum jaws upward.