Ramsey Winch H-800 DOW-LOK (JERR-DAN) - Manual (Page 12)

12
FIGURE 8
If shaft and/or gear hub is damaged, replace as
follows:
a. Tap keys #27 into short keyways of drum
shaft #32.
b. Press shaft #32 and keys through gear hub
#19 until end of keys on long end of shaft
are flush with hub of gear.
FIGURE 9
Check gear housing bushing #10 and o-ring
#86 for signs of wear. Replace if necessary by
pressing old bushing from gear housing #22.
Press new bushing into place and insert new o-
ring #86 into groove inside of bushing.
FIGURE 10
Check drum bushings #41 & #42 for signs of
wear. Replace if necessary by pressing old
bushings from drum #18. Press bushing #41
into bore in drum until flange is seated against
bottom of counterbore. Press bushing #42 into
opposite bore on drum until end of bushing
extends .50" from end of drum.
FIGURE 11
Check end bearing bushing #42 for signs of
wear. If necessary, remove old bushing and
press new bushing into place.
FIGURE 12
Check cover bushing #10 and o-ring #86 for
signs of wear. Replace if necessary by pressing
old bushing from gear housing cover #16.
Press new bushing into place and insert new o-
ring #86 into groove inside of bushing.