Asante Technologies 3624/48 User Manual
Page 120
10.4.7 Log
This command is used to configure log server
10.4.7.1 Log log-server
This command is used to configure log server
1) Log log-server name
characters, add a log server IP address
Format Log log-server name <WORD> add ipaddr word
Mode Global Config
2) Log log-server name
27
Format log log-server name <WORD> delete
Mode Global Config
10.4.7.2 Log logging-target
This command is used to configure log notification level
1) log logging-target memory
This command is used to specify memory log notify-level
Format log logging-target memory {enable|disable}
Mode Global Config
2) log logging-target flash
This command is used to specify flash log notify-level
Format log logging-target flash {enable|disable}
Mode Privileged Mode
3) log logging-target console
This command is used to specify console log notify-level
Format log logging-target console {enable|disable}
Mode Global Config
4) log logging-target server
This command is used to specify console log notify-level
Format log logging-target server name <WORD> {enable|disable}
Mode Global Config
10.4.8 radius-server
This command is used to configure radius server
Format radius-server ip <IP addr>
Mode Global Config
10.4.9 static-address
This command is used to specify static address
10.4.10.1 static-address add
This command is used to add static mac address
Format static-address add <mac addr> vid <vlan-ID> port <port-ID>
Mode Global Config
10.4.10.2 static-address delete
This command is used to delete static mac address
Format static-address delete
Mode Global Config
10.4.10 mgmt-accesslist commands
10.4.10.1 mgmt-accesslist ipaddr
This command specifies a management access IP for the DUT, up to 8 IP
address can be set.
Format mgmt-accesslist ipaddr <IP addr>
Mode Global Config
10.4.10.2 mgmt-accesslist enable
This command enables management access list. Only the IP address
specified in the management list is allowed to access DUT.
Format mgmt-accesslist enable
120
Asante IntraCore IC3624/48
User’s Manual