Chapter 10: cli commands – Asante Technologies 3624/48 User Manual
Page 109

Chapter 10: CLI Commands
The CLI is divided into various modes. The Commands in one mode are not 
available until the operator switches to that particular mode. The commands 
available to the operator at any point in time depend upon the mode. Entering 
a question mark (?) at the CLI prompt, and displays a list of the available 
commands and descriptions of the commands. 
The CLI provides the following modes. 
 
 
10.1 Modes
 
When the operator logs into the CLI, the User Mode is the initial mode. The 
User Mode contains a limited set of commands. The command prompt shown 
at this level is: 
Command Prompt: COMMAND> 
Privileged Mode 
To have access to the full suite of commands, the operator must enter the 
Privileged Mode. The Privileged Mode requires password authentication. From 
Privileged Mode, the operator can issue any Exec command to enter the 
Global Configuration mode. The command prompt shown at this level is: 
Command Prompt: Switch# 
Global Config Mode 
This mode permits the operator to make modifications to the running 
configuration. General setup commands are grouped in this mode. From the 
Global Configuration mode, the operator can enter the Interface Configuration 
mode. The command prompt at this level is: 
Command Prompt: Switch(Config)# 
From the Global Config mode, the operator may enter the following 
configuration modes: 
14 
Interface Config Mode 
Many features are enabled for a particular interface. The Interface commands 
enable or modify the operation of an interface. In this mode, a physical port is 
set up for a specific logical connection operation. The command prompt at this 
level is: 
Command Prompt: Switch(Interface <port#>)# 
 
 
10.2 User Mode commands
 
10.2.1 Help 
This command displays help information 
Format help 
Mode User Mode 
10.2.2 ? 
This command displays help information 
Format help 
Mode User Mode 
10.2.3 logout 
This command is used to exit from the telnet 
Format logout 
Mode User Mode 
10.2.4 ping 
This command sends echo messages. 
109
Asante IntraCore IC3624/48
User’s Manual
