Ramsey Winch H-800 DOW-LOK - Manual (Page 9)

FIGURE 4
Remove bearing cap (item #6) and gasket
(item #35) by unscrewing six capscrews (item
#27) and lockwashers (item #33).
Drag brake disc (item #10), spacer (item
#53), and spring (item #49) should be exam-
ined and replaced if necessary.
FIGURE 5
Remove motor (item #54) from adapter
(item #2) by removing two capscrews
and lockwashers. Remove adapter (item
#2) from gear housing by removing six
capscrews (item #32). Replace pilot
seal (item #47) and gasket (item #35).
Remove thrust bearing (item #21) and
thrust washers (item #52).
Remove worm (item #18) and bearing
(item #20) from gear housing. Use a
soft hammer to gently tap input end of
worm and drive worm and bearing from
gear housing. Once worm has been
removed from housing bearing can be
pressed from end of worm.
Check for signs of wear or damage to worm (item
#18) and bearing (item #20). Replace if necessary.
FIGURE 6
Remove gear housing cover (item #9)
from gear housing (item #14) by
unscrewing eight capscrews (item #26).
Thread two of the capscrews into the two
tapped holes of cover and tighten. This
will pull cover loose from gear housing.
Remove cover gasket (item #36) and
pull shaft (item #16), with gear (item
#12) and spacer (item #51) attached,
from gear housing.
7