Ramsey Winch H-800 DOW-LOK - Manual (Page 13)

FIGURE 16
Place winch with gear housing cover down on work bench. Drum
shaft should be in vertical position. Set springs (item #49) into
pockets of gear housing with drag brakes (item #10) on top of disc
(item #53) and springs. Slide drum assembly (item #14) onto
drum shaft as shown.
FIGURE 17
Place clutch (item #7) over end of drum
shaft. Align the clutch over the pilot bushing
in drum. Install the eight capscrews (item
#28) and torque the capscrews to 103 ft-lb.
(139 Nm.) to securely seat the clutch to the
drum.
Rotate the drum to align the clutch slots with
the shaft keyways. Lightly grease four dowel
pins (item #44) and eight balls (item #19).
Use molybdenum disulfide or graphite bear-
ing grease. Insert the four dowel pins (item
#44) and eight balls (item #19). In the
engaged position the balls are nearly flush
with the clutch.
Lightly grease the internal and external
groove and bore in locking ring (item #8) and clutch (item #7).
Slide locking ring onto the clutch. When fully engaged, the locking ring
touches the clutch flange and there is .71 to .73 inches between the end of
the locking ring and the end of the clutch.
11