Ramsey Winch H-800 DOW-LOK - Manual (Page 11)

FIGURE 10
Check drum bushings (items #22 &
#23 for signs of wear. Replace if nec-
essary by pressing old bushings from
drum (item #11). Press bushing (item
#22) into bore in drum until flange is
seated against bottom of counterbore.
Press bushing (item #23) into opposite
bore on drum until end of bushing
extends 0.50" from end of drum.
FIGURE 11
Check end bearing bushing (item #23) for
signs of wear. If necessary, remove old bush-
ing and press new bushing into place.
FIGURE 12
Check cover bushing (item #4) and o-ring
(item #40) for signs of wear. Replace if neces-
sary by pressing old bushing from gear housing
cover (item #9). Press new bushing into
place and insert new o-ring (item #40) into
groove inside of bushing.
9