Ramsey Winch H-800 DOW-LOK - Manual (Page 8)

INSTRUCTIONS FOR OVERHAUL OF
RAMSEY MODEL H-800 DOW-LOK®
DIS-ASSEMBLY
Refer to parts list and parts drawing pages for
actual Item numbers and corresponding
parts numbers.
FIGURE 1
Drain oil from gear housing by removing
pipe plug (item #42) from gear housing.
Shift clutch into the engaged “IN” position.
Remove frame angles (item #3) from winch
assembly.
FIGURE 2
Remove two capscrews (item #29) from
clutch housing (item #13) and unlatch shifter
assembly.
Remove clutch housing from end of drum
shaft. Press in on retainer plate (item #46),
to relieve the spring tension and remove the
retainer ring (item #48).
Remove four capscrews (item #24), retainer
plate (item #46), springs (item #50) and
spacer (item #17).
FIGURE 3
Slide the locking ring (item #8) from the clutch.
NOTE: The locking ring cannot be removed
unless the clutch is engaged, with dowel pins
(item #44) seated in the shaft keyways.
Rotate the drum so the eight balls (item #19)
and four dowel pins (item #44) can be
removed.
If necessary, the clutch (item #7) may be dis-
assembled from the drum by removing eight
capscrews (item #28). Slide drum (item #11)
from drum shaft.
6