Ramsey Winch H 700 DOW-LOK W/ COUNTERBALANCE VALVE, LESS BRAKE - Manual (Page 9)

INSTRUCTIONS FOR OVERHAUL OF RAMSEY MODEL H 700 DOW-LOK®
Refer to parts list and parts drawing pages for actual
item numbers and corresponding parts numbers.
(1)
Drain oil from gear housing by removing pipe plug (item #54)
from gear housing. Shift clutch into the engaged "IN" position.
Remove frame angles (item #4) from winch assembly.
(2)
Remove two capscrews (item #32) from clutch housing
(item #15) and unlatch shifter assembly. Remove clutch housing
from end of drum shaft. Press in on retainer plate (item #59), to
relieve the spring tension and remove the retainer ring (item
#61). Remove four capscrews (item #30), retainer plate (item
#59), springs (item #63) and spacer (item #21).
(3)
Slide the locking ring (item #9) from the clutch. NOTE: The
locking ring cannot be removed unless the clutch is engaged,
with dowel pins (item #55) seated in the shaft keyways.
Rotate the drum so the eight balls (item #24) and four dowel
pins (item #55) can be removed.
If necessary, the clutch (item #8) may be disassembled from the
drum by removing eight capscrews (item #34). Slide drum
(item #12) from drum shaft.
Retain springs (item 62), drag brake shoes (item 11), and brake
spacers (item # 67) for re-assembly.
11 67 62
11
67
62
12
24
8 55
34
9
DIS-ASSEMBLY
4
4
35 44
54
15
32
61
30
59
63
21
7