Ramsey Winch H 700 DOW-LOK W/ COUNTERBALANCE VALVE, LESS BRAKE - Manual (Page 11)

(7)
Check for signs of wear on gear teeth. If necessary replace
gear.
(8)
If shaft or gear is damaged, replace as follows:
a. Tap keys (item #17) into short keyways of drum shaft.
b. Press shaft (item #18) and keys through gear (item
#13) until end of keys on long end of shaft are flush
with hub.
(9)
Check gear housing bushing (item #5) and o-ring (item #52) for
signs of wear. Replace if necessary by pressing old bushings
from gear housing (item #14). Press new bushing into place and
insert new o-ring (item #52) into groove inside of bushings.
18
17
13
52
5
14
(10)
Check drum bushings (items 27 & 28) for signs of wear. Replace
if necessary by pressing old bushings from drum (item #12).
Press bushing (item #27) into bore in drum until the flange is
seated against bottom of counterbore. Press bushing (item #
28) into opposite bore on drum until end of bushing extends .50”
from end of drum.
27
12
28
9