Ramsey Winch H 700 DOW-LOK W/ COUNTERBALANCE VALVE, LESS BRAKE User Manual

Page 12

(11)

Check end bearing bushing (item # 28) for signs of wear. If

necessary remove old bushing and press new bushing into place.

(12)

Check cover bushing (item #5) and o-ring (item #52) for signs
of wear. Replace if necessary by pressing old bushing from gear

housing cover (item #10). Press new bushing into place and

insert new o-ring (item # 52) into groove inside of bushing.

(13)

Slide spacer (item # 52) over long end of shaft and place against
gear hub. Apply grease to end of shaft opposite gear. Apply

grease to bushing in gear housing (item # 14). Place greased
end of shaft through bushing in gear housing (item #14). Place
gasket (not shown) onto gear housing cover (item #10). Apply
grease to gear end of shaft and cover bushing. Place cover onto

shaft and secure to housing with (8) capscrews (item #33).

Tighten capscrews to 39 ft lb (52 Nm) each.

RE-ASSEMBLY

(14)

Place bearing (item #25) onto worm (item #22). Note: Be sure

that thick shoulder of bearing’s outer race (side with
manufacturer’s name and part number) is out, away from worm
threads. Press bearing and worm into gear housing. Slip gasket
(item #47) onto worm cap (item #7). Use (6) capscrews (item

# 36) to secure worm to gear housing. Tighten capscrews to 45

ft lb (61 Nm) each.