Ramsey Winch 800/H-800 DOW-LOK - Manual (Page 16)

14
(16)
Press bearing (item #34) onto worm and into housing. NOTE:
Be sure that thick shoulder of bearings outer race (side with
manufacturer's name and part number) is out, away from worm
threads. Attach bearing cap (item #8) to gear housing using six
capscrews (item #41) with lockwashers (item #52). Tighten
capscrews to 39 ft. lb. (52 Nm.) each. Insert key (item #24) into
keyway of worm shaft.
(17)
Press bearing (item #34) onto worm and into housing. NOTE:
Be sure that thick shoulder of bearings outer race (side with
manufacturer's name and part number) is out, away from
worm threads. Attach adapter (item #3) to gear housing using
six capscrews (item #50). Tighten capscrews to 45 ft. lb. (61
Nm.) each. Insert key (item #24) into keyway of worm shaft.
Slide coupling (item #2) over end of worm shaft. Attach
adapter plate (item #26) to adapter using eight capscrews
(item #48). Tighten capscrews to 21 ft. lb. (28 Nm.) each.
Place motor shaft, with key in keyway, into coupling. Secure
motor (item #62) to adapter, using two capscrews (item
#51). Tighten capscrews to 102 ft. lb. (138 Nm.) each.
(17a)
Place thrust washers (item #74) and thrust bearing (item
#32) over end of worm (item #28) and into housing.
Attach adapter (item #2) with gasket (item #54) to hous-
ing, using six (item #47) capscrews. Tighten capscrews
to 45 ft.lb. (61Nm.) each.
Insert pilot seal (item #68) into adapter and carefully place
motor shaft, with key in keyway, through seal, so as not
to damage seal. Insert motor shaft into end of worm (item
#28). Secure motor (item #59) to coupling using two
(item #48) capscrews with lockwashers (item #52).
Tighten capscrews to 102 ft.lbs. (138 Nm.) each.
8
24
34
56
52
41
2
48
3
26
51
62
50
24
34
57
59
48
47
2
74
68
54
32
28